What the meth? Hack jobs

[pointsnorth]

Who does this?


Sent from my iPhone using Tapatalk

[Snowracer]

looks good to me

[pointsnorth]

Guy was complaining about getting 3/4 on an inch of runout lol


Sent from my iPhone using Tapatalk

[Snowracer]

probably still better then a square tube shaft

[Johnny5]

Even looks like it’s got “balancing “ welds lol

[Scott Cee AKA 2drx4]

Whatever they used for a slug inside it must not have been a good press fit... I lengthened the totally worn out driveshaft on my plow truck by putting a slug in the slip yoke part of it, it was a good press fit, and the thing didn't vibe any worse than it did before I monkey'd it.

[pointsnorth]

Had to share this one wow


Sent from my iPhone using Tapatalk

[Johnny5]

Instant 5 spoke “aftermarket” rim

[Mr.gutsy]

received_779505605829698.jpeg (45.09 KiB) Viewed 1523 times

[pointsnorth]

received_779505605829698.jpeg

I actually though this pictures was making me tear up. Nope it’s blood my eyes are bleeding right now


Sent from my iPhone using Tapatalk

[Johnny5]

I love the tough looking knuckles... like that was the weak point before

[Scott Cee AKA 2drx4]

I wanna see the rest of the build that goes with that axle.

[Scoobienorth]

Guess who was dumb and lazy and went to a drive through oil change place last time. ........ took a 24” pipe wrench to break it loose, 18” offset for next half a turn then I used a old ratchet strap and vise grips for the next rotation. Was a turn and a half until I could spin it with my hand. I actually think they got double the turns total more than i did putting the new one on.

[Helidump]

on a scale of foot lbs to the torque created by the rotation of the earth, how tight was the drain plug? Ive seen those fellers break an oil filler cap too. Big beefy arms on em I guess?


Sent from my iPhone using Tapatalk

[Scoobienorth]

on a scale of foot lbs to the torque created by the rotation of the earth, how tight was the drain plug? Ive seen those fellers break an oil filler cap too. Big beefy arms on em I guess?


Sent from my iPhone using Tapatalk

Actually I needed big slip joint plier to remove the filler in the valve cover too. The drain oddly enough was tight but not ridiculous over done